Candy Shake : Haz tu dispenser dulces / / DIY Candy Dispenser

This is a very nice DIY project. Do a candy dispenser with a plastic cup, cardstock and sweets of various colors, we'll call it "Candy Shake" Material: cardboard or thick cardstock, pieces of cardstock of many colors to decorate, thick cardboard it can be whatever you want table and cutter, ruler, permanent markers, an object with rounded edge to mark the fold, you can use something like this or even a pen without ink scissors, glue stick or double sided tape, pencil, eraser, cold silicone, perforators a small glass, cover, straw and sweets of various colors and shapes Let's start with the cardstock, make a piece of 29 x 22 cm I´ll trace with white pencil to apreciate better make lines at the top and bottom edge at 1, 8, 15 and 22 cm First make the marks then join them now make marks on the right and left side at 2, 9, 14 and 21 cm it´s really important to start from bottom to top you´ll have a grid like this draw with the pencil tabs here and here I will scratch the rest, this is the leftover we will remove make tabs also in this 3 sides of the squares I recomend you to download the measure guide to make it easier this procedure I´m going to scratch the rest taking this line as a guide, make marks at 3 cm on each side Join them with a line and scratch the rest make a tab here make lines at 2 cm on this rectangles and scratch the rest in the new lines, make marks at 1 cm And with the ruler, draws a line from this side to the edge the piece should look like this cut the scratched area don´t throw the leftovers, you can save them for the next projects with the ruler and marker, trace a square of 1.5 x 1.5 cm at the center of the glass it does´t have to be right in the center the important is that the size of the square is big enough to let the sweets pass through there cut with the cutter, be careful while cutting try not to press too hard or make uneven cuts, you can use the ruler to help you Take the base, put the glass over this square in the center is important to put it as well centered as possible mark the outline of the cut with the cutter then cut it from the cardstock Verify that the square on the card stock is like the square of the glass if it´s smaller, the sweets can´t pass through there fold every line of the figure, to make it easier pass an object with rounded edge on each line you can use something like this or even a butter scoop you´ll see it´s easier to fold lets assemble the piece Put glue on this 2 tabs glue them over here put glue here and glue this tabs inward you can also use double sided tape glue this part this way you should have this to finish, insert this tabs inside the figure verify it works, it should open and close a little glue the glass over the figure before gluing, make sure that the square of the glass match with the square of the box use cold silicone leave the figure dry while take a piece or paper or cardstock to make a rectangle of 25 x 2 cm decorate with stamps, messages or figures of your perforator glue it in the glass make a square of 9 x 9 cm in the thick cardboard of your preference decorate it as you prefer I´ll use deco paper and round the edges glue the box in the center insert the sweets in the glass, they will fall slowly into the box push this inward to hold the sweets I recommend you to fill the glass halfway maybe the card stock can not handle the weight put the cover, insert the straw and you finished.!! now you have a nice detail, how would you use it? as decoration or gift the end if you enjoyed this video, remember to subscribe and share with your friends learn other techniques and this videos visit the website www.craftingeek.me bye