Igo - S a igo - L rebuildable atomizer od gold drive

Hello. Today we'll take a look at two small direct dripping atomizers, that are also rebuildable, and they are called IGO-L and IGO-S. So what are their accessories? Both packages are the same. Two sealing rings, one spare screw for the coil attachment, a piece of kanthal and a piece of wick. So that's accessories for IGO-L. It's really the same with IGO-S. And lets take a look at those atomizers. They bothcomes without the 510 drip tip. You have to use your own. So here you see the difference in the diameter. So IGO-L has 20 mm. And the IGO-S has 14 mm. Both are the same height - 18,5 mm. So that was the main difference between those two drip atomizers. If you want to disassemble those is better to put it on some device. Then you can just easily take the cap off. Both atomizers comes without the heating system. Therefore you have to make your own coil, with the help of accessories in the package. I have already made coils for both atomizers. In IGO-S I used the wick and in IGO-L I used braided mesh. Those are just my setups it's really up to you how you make your coil. Both atomizers has two pins, the center pin and the pin on the side. There is also a difference in attachment. IGO-L has no holes for the kanthal, you have to place it under the screws. And IGO-S has the holes and you can push the kanthal through. So that was the differences otherwise the atomizers are the same. I prefer to use those types of atomizer on mechanic grips, now I just want to try if it works. The resistance of this coil is 1,5 ohm. As always, set the air hole right in front of the coil. So this one is ready. The resistance on this atomizer is 1,2 ohm. Now the IGO-L and IGO-S are ready to vape. These two atomizers will be only as good as the coil you make. Into this one you can get around 10 drops of liquid. And here it's less of course. It works, as you can see. And IGO-S. So I hope those beauties will work fine for you. And see you again. Bye.