Tutoriel - Diy - Comment faire un bracelet shamballa - How to make a shamballa bracelet

How to make a shamballa style bracelet Hello, today I'am gonna to show you how to make a shamballa style bracelet This bracelet can increase connection between body and soul A return of basic such as love, compassion, empathy, tolerance and ethical its brings meditation and understanding of either I hope you like this tutorial Select the beads of your choice Put them aside Take a clipboard to catch the thread, you can use scotch tape Take the wire, measure the length you need with your wrist and cut Before cutting, leave a thread surplus of 15 cm (6 inches) that is important to the clasp Pinch the wire Insert the selected beads Wire stuck down with tape or a clamp Take about 1.50 m of wire (1.7 yards) Cut it and slide it under the middle wire To start braiding you simply make a knot How braiding? First pass the left thread above the middle wire The left wire should be parallel to the right wire Then the right wire should go above the left wire Pass the right thread below the middle wire Finally pass the right thread below the wire left Insert the same wire into the loop Tighten Go and do the same things in reverse Pass the right wire above the middle wire The right wire should be parallel to the left wire Take the left thread and place it above the right wire Pass the left thread to place it below the middle wire Finally, place the left wire below the right thread and insert it through the loop Tighten You can continue braiding and do not forget to switch (LEFT / RIGHT / LEFT / RIGHT) A tip To know which side you start braiding : If a loop is prominent on the left, we must begin with the left (eg the image is left) To add a pearl it's simple Slide a pearl, and wrap it with the wire by the braiding method presented above left wire above the middle wire right wire above the wire left right wire under the wire middle , then below the left thread and insert it in the loop Continue the other side, starting with the right Before finishing, make sure the bracelet is properly adjusted It does not completely surround the wrist I left a space between the ends Cut off excess wire, you'll keep If it's in plastic thread, you can burn the excess Otherwise put some super glue on the ends To regroup together the two ends Put them side by side Take the excess wire you cut earlier Pass it into the bracelet Make a knot with and do not overtighten You can easily expand or tighten the bracelet Add pearls to the wire that adjust the bracelet So you will not be confused with the wire used for braiding Start braiding around the two wire that adjust the bracelet For the braiding is exactly the same technique I refer you to the beginning method Braid until obtaining the desired length Finally cut the surplus, ie the wire which does not have beads at their ends And voilà You can make different bracelet styles. Choose your favorite beads and wire color I hope you enjoyed this video Bye Bye