Video aula - Soldagem com eletrodo revestido Pos. 5G Filler layer and cap layer with SMAW stick

Here is me and my friends welders "TITO" and "ROMISCLEI" The ROMISCLEI is also the state of Alagoas and he is a certified welder in the welding position 6G in the SMAW welding process. To facilitate the welding with SMAW process, use " a whip lead like this very flexible, we removed the stranded copper wires and put it in a flexible hose that leaves the cable well soft how you see here. The root pass was made with the TIG process We apply liquid penetrant and developer To eliminate any discontinuity that could have happened in the root pass, we remove the developer with a wire brush and is ready to start the filling with the SMAW Process Here the welder starts the first pass using electrode AWS E7018 2.5 mm (3/32") in diameter Watch now through the lens. Note the position of the electrode to prevent the weld pool drain. Now he is up to with the electrode, Note it moves with the electrode with a small movement of oscillation because there is no space for two weld beads. Before making the amendment of the weld bead, clean well the end of the previous pass to not stay with the inclusion of slag. Note now that he pull the electrode, this will give more volume in weld bead in this position of the tube. Watch now through the lens Now the welder makes a good cleaning of the weld bead, removed All slag He also makes two guides at the corners of the weld bead to use as a reference for the next pass Notice the two guides that will facilitate the travel. of electrode. Note the welder position and of electrode Note that the welder moves in speed straight and without any oscillation. Here we complete the pass, but without even brushing Here again the welder Make a cleaning with a rotating brush Here the welder concludes the filling passes and now will correct the imperfections. to make the finishing passes first he uses this metal belt to scratch and mark where it will be started, the finishing passes for the weld beads are not misaligned. Now he carefully makes the guide where will be made the weld bead See here, the guide. now he flush the welds For the weld beads be at the same height If the welder did not make this guide before grinding these welds, he would be lost now and would not do it correctly. Here is a view, of the first finishing pass Start of second finishing pass at position over-head. Again note the position of the electrode to the weld pool does not drain. Note the position of the electrode uphill now. So far all passes, with the exception of first pass filler all others were made without oscillation. here we have the end result Tkan you for watching