Como Terminar Gorro - Boina en telar circular

finishing the hat on the previous video there was technique problems the video of how to close the bonnet, was not recorded so by the time I finished closing the bonnet there was no video so the next day with the excess yarn, I did some laps to show the procedure in this video there wont be a bonnet shape but the procedure is the same...good luck!! to close, take out with the hook on the last point where is the yarn once is outside, take the stainless steel hook pass through the middle and pull the yarn to make it like this I´m going to show you the same but nearest you have the last point, take it out take the stainless steel hook pass the hook through the middle and pull the yarn flip the loom take out all the points and put them on the needle pull until the end you just have to have near the needle the threads will be accommodated by them self once they are outside take the thread we had and put it onto the hook carefully make sure it is at first take the other points above this thread when you finish pull the thread as much as possible take the scissors and cut the excess pass it throuhgt the middle of this thread keep pulling and arranging to make it a circle like this once its well tighten, take the needle and introduce the strip put it in the middle of the circle pull and flip the bonnet you´ll have something like that pass the needle between groups of yarn around the circle tight as much as possible when you have given about 2 or 3 laps of the circle make a knot introduce and pull and you will have a circle pass the needle through the middle and pull now loose the yarn, pass the needle again and cut and ready you finished the bonnet