Pavimix Scm From Mold At Finished Product

Personal Factory presents PAVIMIX SCM - complete cycle from the mold to the finished product perfectly seal the model to copy fill against the undercuts with a mortar made of plaster around the model achieve a perfectly sealed timber formwork ensure that the work plan is level and that there is no leakage proceed to the casting mold with rubber to two-component silicone average hardness fully cover the model let dry for at least 24 hours at a temperature between 18 ° and 26 ° C it is finally possible to unmold. the elasticity of silicone avoids the problem of small cons undercuts clean and dry the mold carefully back around the silicone mold the formwork used previously remove any residues of the original model possibly using hydrochloric acid preparation of PAVIMIX SCM mix PAVIMIX SCM with 14% water let stand for 5 minutes the mortar very slowly pour the mortar into the mold to allow air bubbles to escape more easily allow to dry for at least 6 hours unmold be achieved with PAVIMIX SCM ripen the subject for 48 hours before any further operation Discover all the innovations proposed by the Personal Factory on website www.personalfactory.eu and on blog www.francescotassone.it