Gear Project 2

So, this is how it all started. A just bougt my 3D-printer and I wanted to try it out, so I decided to print gears. I made these as my first project. It's called the gear painting and you can find it on Thingiverse. All the part are there. There's no bearings or anything, it's just basically nails with printed parts on them. So, that was the first one. I decided that if I could do gears, I could probably do some other advanced mechanics, so I decided to do a Gear Project. and... I hade a free space in our staircase. A free wall which is about four meters high and two meters wide. That's the whole space. So, I put the whole project on the wall. Emm... It's basically six frames, three white and three black. And then eh, everything is driven from this third frame Eh, there is the driving gear coming from motor in the boxes at the side there Aemm, They're not lined up perfectly. I will a redesign of the boxes. But that's how it looks. And the motor is coming in right there, that's the driving gear. and the this one goes up to other frames up here. and the last one, this one goes down here. So, it all drives like that, it's a double gear. teeth at the top and teeth at the side. The theeth at the side drives the gears inside the frame and, the ones on sticking out, like this. Then there is the axes coming with the universal joint driving the next frame. There is a RJ11 connection which connects the... lighting. As you can see, it's lit. Connects the lighting down to the next frame and up to the next frame. so if you go down here to the next frame. And then... it's black, and then you have the driving gear white instead, the doubble gear, and the... white gears is coming out, and it goes further to the next frame... The same idea. Ahemm... The RJ11 connection is used to... to just to just have the lighting so if I pull this one It looses the light. Very simple. Ehm... This is the top part, it's about 3 meters from staircase. Then it gose the next one. It's two white gears sticking out on this frame. And then, the universal joints again of course to the next one like this. One black gear is sticking out. The motor is quite strong. So, it's not a good idea to put your finger like this... I think you will hurt. But eventually... something will probably break before your finger breaks, but it will hurt. And there is all ball bearings everywhere, so, on the gears have ball bearings, this is M6 screws. Ball bearings on everything. On the holder there is a ball bearing. and there is a, ball bearing on the holder right there. And the same on every frame everywhere. In the universal joints as well. Ball bearings... So, it's very quiet. The whole idea whas that it should be quiet so it should not disturb anyone. for the moment the... the motor is a little bit noisy. It is something wrong with, so I will change it. when I get the new one. So this is the whole thingie... and is there is a, uh... Remote controll to controll the lighting so if I do red here, the thing is red. Green, it's green, And blue of course, and white. You can also be changed the amount, change how, how... bright it should be. Very nice. Ehh.. Yea, that's about it I think.